ciiler

The installation of the sink should have steps and the order should not be reversed, otherwise it is easy to have problems! Especially during the construction process, workers need to pay attention to each installation step. Hiller Bathroom shares with you
1. The position of the sink should be reserved properly
The first step is to reserve a sink space and provide the approximate size of the sink when ordering. It is best to provide a floor plan of the sink to avoid rework due to customization discrepancies. When installing the sink, the position left on the countertop should match the volume of the sink. The sink should be installed firmly and the body of the sink should not shake left or right. The installation of the sink is not a major project in the entire decoration, but it is important to pay attention to the sealing of the connections during the installation process.
2. First, install the faucet and inlet pipe
The second step is to install the faucet and inlet pipe before installing the sink. In addition, one end of the inlet pipe on the faucet is connected to the inlet switch.
3. Place the sink on the countertop
After placing it on the countertop, it is necessary to install matching hanging pieces between the slot and the countertop. The sink should be installed firmly and the body of the sink should not shake left or right. The installation of the sink is not a major project in the entire decoration, but it is important to pay attention to the sealing of the connections during the installation process.
4. Sealing of overflow holes and filter baskets
The sealing degree of the overflow hole and filter blue affects the future use of the water tank, so the sealing degree of the overflow hole and filter blue is very important. After installation, it is necessary to check the sealing condition of the overflow hole and filter basket.
5. Install supporting hanging pieces
The final step of installation is to install the matching hanging pieces for the sink. Generally, after the sink is purchased at home, workers will cut the cabinet countertop according to the size of the sink. After placing it on the countertop, matching hanging pieces need to be installed between the sink and the countertop. During installation, it is important to avoid small gaps that may cause the tank to shake, in order to prevent water leakage in the future.
6. Drainage test and edge sealing
After installation, a drainage test should be conducted to fill the sink with water and test the drainage of the drain and overflow holes. If any water seepage is found during drainage, it should be immediately reworked. After the drainage test, if there are no problems, the edge of the sink can be sealed. When sealing with silicone, it is necessary to ensure that the gap between the sink and the countertop is even and there is no water seepage.